With the rapid development of big data on the Internet, high-speed stranding wires are being sold to various places, gradually replacing the old stranding equipment. Compared with the previous high-speed stranding machines, the existing high-speed stranding machines not only feature high speed, low noise, ease of operation, and a complete detection and alarm system, but most importantly, the stranded wires are rounder and the stranding distance is more stable.
But no matter how good the equipment is, malfunctions are inevitable. As the production of stranding machines increases, various problems have emerged. This article mainly introduces several common faults of high-speed stranding machines: disengagement, wire breakage, spikes, noise, and burn problems.
Ex-dividend: Also known as ex-rights and stock dividend Causes:
1. Uneven tension: the core that is too loose or too tight will deviate, causing back ply.
2. The mold hole is too large and cannot be properly adjusted.
3. The mold position is inappropriate, and the twisting angle is unreasonable.
4. The pitch is relatively large.
Exclusion method:
1. Improve the steel strand unwinding device
2. An advanced single-line tension regulator is used, allowing the tension of each individual line to be adjusted.
3. Hoist products can reach the level of steel strands.
4. Using the method of re-rolling through the mold can meet the usage requirements.
5. The pitch ratio should be appropriately adjusted.
But no matter how good the equipment is, malfunctions are inevitable. As the production of stranding machines increases, various problems have emerged. This article mainly introduces several common faults of high-speed stranding machines: disengagement, wire breakage, spikes, noise, and burn problems.
Ex-dividend: Also known as ex-rights and stock dividend Causes:
1. Uneven tension: the core that is too loose or too tight will deviate, causing back ply.
2. The mold hole is too large and cannot be properly adjusted.
3. The mold position is inappropriate, and the twisting angle is unreasonable.
4. The pitch is relatively large.
Exclusion method:
1. Improve the steel strand unwinding device
2. An advanced single-line tension regulator is used, allowing the tension of each individual line to be adjusted.
3. Hoist products can reach the level of steel strands.
4. Using the method of re-rolling through the mold can meet the usage requirements.
5. The pitch ratio should be appropriately adjusted.